AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Dominator garage door opener manual9/16/2023 ![]() ![]() If you want to delete the code in LED#1 push and hold the PROGRAMME button down until the light starts to flash. ![]() After several seconds all lights will flash on and off. Disconnect power for 20 seconds then reconnect powerģ. If any existing remote is affected, re-program that one too. If you can’t See any LEDs flashing, maybe the door opener has been fully coded, then you will need to delete an existing code and re-program the new remote. Wait for 10 seconds, then press the transmitter button to test if it works.When a flashing LED has been found, press and hold new transmitter button until the LED stops flashing and is illuminated.If LED#3 is still illuminated, keep repeating the steps until find one of the LEDs flashing, that means you found a vacant memory location, (indicated by flashing LED). If LED#2 is still illuminated, press the PROGRAMME button once again LED#3 will be flashing or illuminating.Press PROGRAMME button once again LED#2 will be flashing or illuminating. If illuminated it means a code has already been stored in this location.(The four LEDs will flash on and off two times after which LED#1 will be flashing or illuminating). Press and release the PROGRAMME button 2 times.4.1 Related Manuals / Resources DOMINATOR DOM501 Garage Door Remote ![]()
0 Comments
Read More
Leave a Reply. |